major

559Currently online
112Today's Reading
16Share Today
Multilingual display

Maserati engine disassembly method and sequence part two

2018-04-29 00:00:10

Maserati engine disassembly, road and line disassembly method and sequence.

Tools/Materials
1

Skidar Tools

2

A Maserati car

External circuit disassembly
1

Remove the plate connector gasket and remove the power cord from the body hole (1).

2

Remove the engine harness bracket (1) and remove the suspension strut connecting beam (2).

3

Remove the cable ties shown and disconnect the heater inlet (1) and return water (2).

4

Remove the transmission harness from the appropriate retaining clamp.

5

Remove the retaining clip and disconnect the quick connector (1) of the vacuum system circuit.

6

Remove the open circuit and disconnect the oil quick connector (1) from the corresponding fixing clip.

7

Pull the lock plate and disconnect the left engine control unit connector.

8

Unscrew three engine harness bracket fastening screws.

9

Slightly pull out the harness bracket and loosen the 2 screws holding the upper engine connection mechanism.

10

Disconnect the quick connector of vacuum system circuit (1) and remove it from the corresponding holder.

11

Disconnect the transmission manual release quick connector (1) and detach it from the 2 retaining clips.

12

Loosen the retaining nut of the right shock absorber. Execute the same program on the left.

13

Loosen the screw shown at the left front wheel cover and disconnect the ground cable.

14

Disconnect the left rear oxygen sensor connector (1) and remove the harness from the appropriate retaining clip.

15

Disconnect the steering gear connector.

16

Loosen the 3 screws shown and remove the heat shield (1).

17

Remove the steering harness from the retainer.

18

Loosen the screw shown and detach the steering column from the steering machine.

19

Loosen the fixing screw (1), loosen the fixing screw (2) and disconnect the air conditioning system from the condenser (3).

20

Loosen the screw (1) and loosen the screw (2) securing the left front stiffener support.

21

Remove air conditioning compressor (1) route through the stiffener support and cooling unit.

22

Disconnect from the radiator to the hydraulic power steering Modine heat exchanger.

23

Disconnect the electric pump transfer from the tank.

24

Loosen the screw shown and disconnect the oil from the hydraulic power steering tank to the heat exchanger (l)

25

Loosen the retaining nut on the right front upper joystick ball head from the hub bracket.

Matters needing attention

Pay attention to the sequence when removing the cable to prevent the cable from being broken.

Recommendation
0.084787s